Hey guys! So today I wanted to show you a fun little trick I have learned while making jewelry. These are two little copper knot earrings, I used whatever I had at my house to make these! 20 gauge copper wire was used ( which is smaller than normal earring gauge, normally 18 is used) I also used my fingers and scissors to help bend the wire.
To start I left the wire on the spool and just started bending the wire until I was satisfied with how it looked.
I used scissors to help bend the wire as well since I didn’t have wire looping pliers. These sufficed to help make these super cute earrings, to finish them off I would try my best to make sure the end was long enough to go through the ear piercing and then cut the end.
For more information or any questions feel free to contact me!
Have a great day and let me know if you tried this as well and how it turned out for you!